|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
 ;
The manual was exact the thing that was promised. My old car stereo is working again thanks to the information supplied.
;
I PURHASED THIS PRODUCT BECAUSE I WAS HAVING PROBLEMS WITH MY CDR20 HARMAN KARDON RECORDER. WHICH I PURCHASED NEW 12 YEARS AGO. AFTER REVIEWING THE MANUAL, I WAS ABLE TO ADJUST THE TENSIONER IN THE SYSTEM. WORKS LIKE A CHAMP!.
SAVED ME AT LEAST 100.00 WHICH WAS WHAT A SERVICE REPAIR STATION WANTED. GREAT MANUAL EASY TO READ. SPECIALLY AFTER I PRINTED THE PAGES WHICH DEALT WITH MY RECORDER. THANKS A LOT!!!!!!!!
;
You can fully trust on this one!
All the schematics are very crear an in one piece per page
;
I have never bought a service manual which is as competely readable as this althogh it was a scanned pdf. Thank you for this succesful manual also cheaper than other sites.
MC-V5241-00
5. Pull or pry out the agitator pulley and agitator holder. 5. Rotate the agitator assembly by hand to insure nothing rubs and to check for correct assembly. 6. Replace the lower plate as outlined in the LOWER PLATE REMOVAL/INSTALLATION section.
3.4.
BRUSH REPLACEMENT
1. The agitator brushes should be replaced when the brushes are worn. Brushes should be checked by holding a card across the lower plate. If the bristles on the agitator assembly do not touch the card you should replace all the brushes for best cleaning results.
6. Push each brush out of the agitator.
3.4.1.
Removal
1. Remove the lower plate as outlined in the LOWER PLATE REMOVAL/INSTALLATION section. 2. Remove the agitator assembly as outlined in the AGITATOR ASSEMBLY REMOVAL/INSTALLATION section. 3. The agitator assembly may now be dissassembled and the brushes replaced. 4. Carefully remove the E-clip from the agitator shaft, do not misplace. Remove the right brush support. Pull the agitator shaft out of the opposite end of the agitator.
3.5.
3.5.1.
NOZZLE HOUSING and NOZZLE REPLACEMENT
Removal
1. Remove the lower plate, agitator assembly, and belt as outlined in their respective sections. 2. Remove the nozzle hose by pulling up on the hose supporter to remove it from the nozzle housing. Pull the nozzle hose out of main body and remove from vacuum. 3. Remove the headlight assembly and reflector by following the instructions relating to the removal of these items. 4. Remove three (3) screws from pedal assembly. 5. Insert a flat blade screwdriver between the nozzle housing 11
|
|
|
> |
|
