|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This service manual of the old video cassette recorder VT-LC50EM is very good readable even the tiniest numbers (i.e. IC-pins). The circuits are very clear. Many details of the schematic are very good described but in GERMAN language. Many schematic details - but complete at all. Common background information of several details are enclosed and physical knowledge of the TFT liquid crystal display for example. The manual lacks PCB drawings. If you understand german I would recommend this manual for you.
 ;
Hi, this is a very clear manual, nice copy, not quite up to the standard of the very best available but better than many others. I think the price was especially fair for a hard to find manual and I would certainly use this manual seller again. Recommended.
 ;
This schema available for me in good condition. I would highly recommend.
 ;
Thanks for this "hard to find" service manual.
I apreciate the good quality of scanning and the pages scanned in A3 format.
 ;
Helpd me mont a new carradio when prewius mont was a mess.
3.8.
3.8.1.
Power Cord Replacement
Removal
Assembly
3.9.2.
Installation
1. When re-connecting lead wires to ON/OFF switch make sure the insulated lead is reconnected to its original location as shown.
1. Refer to Handle Assembly Replacement Section. 2. With handle removed from body disassemble handle by removing fourteen (14) screws. Refer to Handle Assembly Exploded View. 3. Remove handle release button and spring. 4. Remove damaged cord.
3.8.2.
Installation
1. Replace damaged cord. carefully routing power cord as illustrated. 2. Reinstall handle as outlined in the handle installation section. 3. Replace the cord stopper, the two (2) cord stopper screws and the wire connectors. NOTE: Never reuse a cord stopper. Always install a new cord stopper whenever the old one is removed. NOTE: For general servicing, it is necessary to eliminate pinching of any wire during reassembly. After servicing any electrical component or electrical enclosure, the vacuum cleaner should be reassembled and checked for dielectric breakdown or current leakage.
3.9.
3.9.1.
ON/OFF Switch Replacement
Removal
1. Remove the dust cover to expose the electrical connections of the ON/OFF switch.
2. Remove the insulated black wire lead from switch. Note the location of the insulated lead when removing from switch. 3. Remove uninsulated black wire from switch. 4. Remove the ON/OFF switch, (for ON/OFF switch replacement) by depressing the switch retaining tabs while pushing up out of the dust compartment at the same time.
15
|
|
 |
> |
|