|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Manual was reasonably easy to follow. I am not an engineer or know much about electronics but with the manuals help I was able to figure out the problem, identify the part required for the repair. Replacement part cost around $30. Whilst replacing the part I was telling myself, "this aint gonna work cos it seems far too easy". Took about 15 minutes to do and my plasma TV works a treat. Would never have been able to do this without the service manual.
;
It is OK, this manual help me to repair my dynacord
 ;
Good manual. Even it is an old printed manual, it is well scanned and complete, with all drawings, schematics and parts list. Very good return for the cost.
;
I'm very satisfied with my purchase. It resolved my problem. Owner-manuals.com is a very very good place.
Thank you!
;
Veramente completo, dettagliato e perfetto nella visione. Perfect, thanks!
3.11. Motor Assembly Replacement
3.11.1. Removal
1. Remove the dust cover by removing the eight (8) screws (see section 2.1.1). 2. Remove the lower plate, agitator assembly, belt, the plastic shaft and the nozzle housing as instructed in the respective removal sections. 3. Disconnect the motor leads and remove the motor. Remove the motor support rubber (rear), noise suppressor, flange and the motor support rubber (front).
3.11.2.
Installation
1. Place the motor back into the dust compartment with the tabs on the flanage aligned parallel to the front edge of the dust compartment.
2. Rewire per the Pictorial Wiring Diagram and Wiring Management Drawing. 3. Replace the dust cover and the eight (8) screws. 4. Replace the nozzle housing assembly, belt, agitator assembly, and lower plate according to the respective installation instructions.
15
|
|
|
> |
|
