|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Wellll again thank you very much fast and effective. Clear and well done for such an old TV!!!!
;
It has all the information you will need to fix it. The main circuit diagram is only A4 but being a PDF, you can print it to any size - I did it on two sheets of A3 and it didnt lose any detail - just made it readable when pinned up above the bench. I've found the fault, just need to buy some obscure bits to get it going again!
I cant fault the process, I paid for the manual in the morning and it was ready to download by lunch time.
 ;
Very good copy in a 54 pages PDF archive. This is my sixth purchase here. :)
;
Another excellent buy! File too clear and explanatory.
;
A manual hard to find. It was very helpful to restore my device.
MC-V5745-02
3.6.
3.6.1.
Nozzle Housing Replacement
Removal
1. Remove the lower plate as outlined in the LOWER PLATE REMOVAL/INSTALLATION section. 2. Remove the belt and agitator assembly as outlined in the respective sections. 3. Remove the nozzle hose, for nozzle hose replacement by pulling it up out of the nozzle housing and then pulling it, while twisting, out of the tool holder. 4. Remove the headlight assembly and slider support by following the instructions relating to the removal of these items. Pull the headlight wires from the grooves in the nozzle housing. 5. Insert a flat blade screwdriver between the nozzle housing and the plastic shaft, pry out the plastic shaft as illustrated.
NOTE: If the motor case cover is removed, DO NOT turnvacuum over as the motor may fall out.
3.6.2.
Installation
1. Install the window, light cover, handle release assembly, and furniture guard in the new nozzle housing. 2. Fit the nozzle from the motor shaft side first, and rotate it into place on the dust container as illustrated.
6. Remove the nozzle housing as illustrated.
3. Slide the plastic shaft through the nozzle housing and into the dust container. Make sure that the slot on the bottom of the plastic shaft is down and fitted onto the projection. Place the headlight wires back into their grooves.
7. Remove the handle release assembly and furniture guard. 8. Remove the light cover and window, by removing the two (2) screws from the nozzle housing and pushing out on the light cover while depressing the tab that secures it to the nozzle housing.
4. Install the slider support. Install the headlight assembly by following the assembly instructions. 5. Reassemble the nozzle hose by inserting it into the tool holder then place the other end into the nozzle housing with the tab fitting into the slot. 6. Install the belt, agitator assembly, and the lower plate according to the respective instructions. NOTE: For general servicing, it is necessary to eliminate 12
|
|
|
> |
|
