|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Downloaded the manual, reasonably straightforward, pretty much exactly as advertised.
 ;
very helpfull
circuit diagram and sparepart list available
;
Very good reproduction (copy) of original manual. Didn't have a parts list, but schematic was completely labeled with parts. Complete instructions on how to adjust mechanical functions of the 8-track deck. Well worth having and at a very reasonable cost.
;
It's a full manual. All the parts are in there. I haven't found the problem yett, but I am working on it; hope I can rebuild the part myself. To make it more secure and unbreakable this time. Because the part has failed several times before and costs a lot to let it be repaired.
Thanks so much for this rich illustrated and parted manual.
;
I downloaded the document. The manual was complete, well scanned and everything was legible. I could zoom in see what I needed to know. There's not much more that you can ask.
3.6.
3.6.1.
Nozzle Housing Replacement
Removal
3.6.2.
Installation
1. Fit the nozzle from the motor shaft side first, and rotate it into place on the dust container.
1. Press handle release pedal. Lay vacuum back on a flat surface. 2. Disconnect hoses from vacuum. 3. Rotate nozzle housing upward removing floor nozzle spring from dust compartment.
4. Once left side has cleared, remove nozzle housing from motor shaft.
2. Rotate nozzle shaft into groove on dust container. 3. Re-install the dust cover as outlined in the Dust Cover Removal and Replacement section. 4. Place floor nozzle spring into slot on dust compartment.
5. Reinstall dust cover as outlined in Dust Cover Removal and Replacement section.
3.7.
3.7.1.
Lower Plate Replacement
Removal
1. Place the Carpet/Bare Floor pedal in the carpet position and the handle in the upright position. 2. Turn the vacuum cleaner over exposing the underside. Release lower plate by pressing two (2) latches and two (2) locking tabs inward as shown.
3. Remove the lower plate and remove any residue that may exist in the belt area. 12
|
|
|
> |
|
