|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent manual. In addition to the information I needed was a complete description of both electronic and mechanical devices.
Excellent site.
Thank you very much.
 ;
very good and complete manual , it is in english and german is perfect for repair.
;
This manual is complete and of high quality. I am very pleased with the purchase.
;
Another excellent buy! A fully readable PDF archive. Good prints!!
;
It is wonderful done!!! a great job in scanning the manual. Superior quality in all the electric scheme. Very understandable and net!!! Thank you!
EXPLODED VIEW (POWER NOZZLE, AND AGITATOR ASSEMBLY)�
A BLOCK
REPLACEMENT OF CANISTER AND RELATED PARTS
CANOPY COVER
A-15 A-16
To Remove:
The canopy cover has a place on each of the four (4) corners where it is locked in place. 1. Place a very small flat blade screwdriver under the side corner as indicated by the arrow in the illustration, (Fig. 16). Pry out until the corner stays out. After popping this corner loose move the screwdriver to the rear corner on the same side. Place the screwdriver under the canopy cover in the same position as the other end was done. Pry out until the cover is loose on this end. Once the corners are free on one side there is no need to pry on the other side. Raise the cover towards the opposite side until it comes off.
Canopy Cover Ends
A-44 A-2
A-14
2.
A-12 A-13
3. 4.
A-1
A-2
A-13 A-22 A-17 A-18 A-20
(Fig. 16)
5.
A-4 A-19 A-23 A-24 A-26 A-27 A-21
6. 7.
A-25
To Replace:
1. Set the canopy cover in position and rap it down on the two (2) corners closest to the power cord end. Tap the other end down to seat both corners.
A-31 A-3
A-29
2.
A-28
A-30
A-4
A-32
A-33 A-34 A-5 A-35 A-37
A-6 A-7
A-36
A-8
A-38 A-42 A-41
A-9
A-10
A-43 A-40 A-43
A-40 A-39
A-11
A-41
�4�
�13�
|
|
|
> |
|
