|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
 ;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
;
This manual is very well presented and after printing out looks about as close to an original as I think you can get. The quality is second to none.
The content of the manual is comprehensive and I think it would be well suited to an audio repair professional which I'm not but I did find it very informative and helpful.
The cost of the manual is more than covered by the money I'll save when I change the keep memory battery now I have the relavant info.
Very pleased with my purchase and can recommend it wholeheartedly as I can other manuals I've downloaded from this site.
Regards
Limey Alex
;
Complete manual including mechanical part in good pdf quality. Shaded greys of the pcb due to pdf not perfect but usable.
;
Nice pdf file of the manual sent promptly. Thanks.
MC-V9634-00
4.4.
4.4.1.
CARBON BRUSH
Removal
1. Complete brush change on one side before starting on the other side. 2. There are two (2) brushes located on the motor as identified in the illustration below.
3. Remove the brush assembly by using a Phillips head screwdriver to remove the screw that holds the brush holder onto the motor. 4. See the illustration above for screw location. NOTE: Do not drop screws into the motor.
4.4.2.
Replacement
1. Place new brush assembly on the motor. 2. Make sure that the amp terminal on the bottom of the brush assembly is inserted into the receptacle on the motor.
3. Replace the Phillips screw that was removed. 4. Repeat steps in Removal & Replacement steps for the other brush assembly. NOTE: Do not drop screws into the motor.
13
|
|
|
> |
|
