|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
MC-V9641-00
4 SERVICE PROCEDURES - CANISTER
4.1.
4.1.1.
HOOD
Removal
1. Lift up on the hood release as the hood is raised. 2. With the hood all the way up, force it until the two ends pop out of place.
3. Lift the canopy cover off of the canister base. 4. Secure the power cord to prevent retracting as you are servicing the motor.
4.1.2.
Replacement
4.2.2.
Replacement
1. Place each end of the hood into the slot while holding upright in the position it was removed. 2. Work both ends into the openings and close.
1. Set the canopy cover in position and secure the canopy with (4) screw holes. 2. Replace the foam over the cord rewind button. 3. Snap the brake pedal in to place on the canopy cover.
4.2.
4.2.1.
front.
CANOPY COVER
Removal
4.3.
4.3.1.
CORD REEL
Removal
1. Remove the brake pedal by snapping it off from rear to
1. Remove hood (see HOOD Removal). 2. Remove canopy cover (see CANOPY COVER Removal). 3. Disconnect both cord reel wires. 4. Remove the cord cover cap from the base. 5. Lift the cord reel straight up to remove. Do this by prying it out of the retainers.
2. The canopy cover has a screw on each of the four (4) corners sercuring it in place. Use a screwdriver to remove each screw.
14
|
|
|
> |
|
