|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
 ;
The manual was exact the thing that was promised. My old car stereo is working again thanks to the information supplied.
(5) Apply Froil G-311S to the pivot of the PF cam and the cam of the PF cam gear.
(6) The cam faces inside. Insert the PF cam gear in the pivot of the PF cam. Note: 1) When inserting the gear, turn the cylinder cam assembly beforehand so that the claws of the paper feed gear are horizontal. At this time, the squared notch of the cylinder cam assembly should face the back. 2) Four-sectored protruding parts of the PF cam gear should face the outside. Engage the center of the protruding part that is horizontal when the inside cam faces down with the paper feed gear.
(7) Apply Froil G-311S to the two cotter pin springs and then insert them in cotter pins. (8) Put the two cotter pins in the PF cam gear.
� 19 �
|
|
|
> |
|
