|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good service and quick service, very good quality of service manual!
;
Great tape deck manual!
I'm very positively surprised, because it is a very long manual, lot of pages, drawings, diagrams, description of how to make the alignment and adjustment procedures.
It is as good as the old "Naka" manuals from the 1970's - if somebody have seen them, they know what I mean by that.
I recommend to buy this very much !
;
I am a vintage hifi collector. No way to fix that device without the appropriate service manual...thanks to your site I got it and every thing is easier now. I got the manual right after ordering: fast cheap accurate ... thank you
;
Wonderful job clear. Qick fantastic. These people are really good. If even a problem arise they are wonderful assisting you. These scheme is so net despite this is a very old TV. Thank you for everything!!!!!!!!
;
Detailed schematic diagram, manual for professionals
DISASSEMBLY INSTRUCTIONS
1-5: FRONT TRAY PLATE/TOP SHIELD (Refer to Fig. 1-5) 1. Unlock the 2 supports 1. 2. Remove the Front Tray Plate in the direction of arrow (A). 3. Remove the 12 screws 2. 4. Remove the Top Shield in the direction of arrow (B).
2 2 2 2 2 2 2 2 3
DVD PCB DVD Deck
2 2 2
Pick Up PCB
2
Make the sort circuit using a soldering.
2
(B)
3
3
3
Top Shield
1 1
(C)
2
(B)
2 2
1
1
Angle Deck
Front Tray Plate
1 1
(A) (A)
DVD Block
Fig. 1-5 1-6: DVD PCB/DVD DECK (Refer to Fig. 1-6) 1. Make the short circuit on the position as shown Fig. 1-6 using a soldering. If you remove the DVD Deck with no soldering, the Laser may be damaged. 2. Disconnect the following connectors: (CP8001 and CP8002). 3. Remove the 4 screws 1. 4. Remove the Angle Deck in the direction of arrow (A). 5. Disconnect the following connectors: (CP2001, CP2301 and CP2302). 6. Remove the 4 screws 2. 7. Remove the DVD Deck in the direction of arrow (B). 8. Remove the 4 screws 3. 9. Remove the DVD PCB in the direction of arrow (C). NOTE When the installation of the DVD Deck, remove all the soldering on the short circuit position after the connection of Pick Up PCB and DVD PCB connector.
AV PCB
Fig. 1-6 1-7: AV PCB (Refer to Fig. 1-7) 1. 2. 3. 4. Remove the screw 1. Remove the screw 1. Remove the AV Jack Shield. Remove the AV PCB in the direction of arrow.
1
AV PCB
2
AV Jack Shield
Bottom Plate
Fig. 1-7
B1-2
|
|
|
> |
|
