|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was very helpfull, it answerdes all my questions, and i was surprized to find the original manual on this site! Big thumbs uP:)
 ;
helpful manual.good service.Quick response.will use again
 ;
Speedy confirmation to my order , with elaborate instructions .
Item Email , received immediately as desired by me.
A Pleasant & Satisfying Transaction.
 ;
I was searching for this manual at last i got it from this web
 ;
What can i say but i would have been lost without your support.
Thank You!
BUILT-IN TALL-TUB DISHWASHER
PRODUCT DIMENSIONS
INCHES
Keep back free of drain inlet water and electrical.
CENTIMETERS
A
Preferred drain area
23 7/8 19 1/2 23 7/8 33 1/2-35 1/4
60.6 49.5 60.6 85.1-89.5
Preferred drain area
B C D
MODEL SKUs
MDB6600AWW MDB6600AWB MDB6600AWQ MDB6600AWS
A
D
B
C
Style of product may vary from picture
NOTES:
1. Minimum 32� drain loop, 1/2� inside diameter minimum. Floor drains require a siphon break. 2. Connections preferably located toward left side of dishwasher. Care should be taken to route plumbing away from motor and blower (if equipped). 3. Electrical and plumbing should meet all local and national codes. 4. Electrical and water supplies should enter cabinet opening on the �oor, or through the back or side walls, as shown in the shaded area of the drawing. 5. When installing dishwasher in or near a corner, allow enough room for door to open without interfering with cabinet drawers or hardware. Electrical requirements: Adequately wired individual 120V A/C, 60Hz approved electrical circuit. Use required fuse (15 amp) or comparable circuit breaker.
Important: Because of continuing product improvements, Maytag reserves the right to change speci�cations without notice. Dimensional speci�cations are provided for planning purposes only. For complete details see installation instructions that accompany each product before selecting cabinetry, making cutouts or beginning installation.
2005-05-06 at 09:21:47 CDT
|
|
 |
> |
|