|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The product was good and just what I needed, however I had moderate difficulty with the down load because the sight would not recognize my pass word. I was finally given a direct link to the manual and that worked.
 ;
Very quick and easy website to use and fast download of manual, quality of manual is excellent and will be pleased to use this service again in the future, thanks so much!
;
It is an very good and clear scanned service manual.
very recommended.
;
Easy to order the manual. Good quality and fast delivery.
;
The Service Manual for Sansui AU-9500 was very helpfull, in complete and in good printable condition.
Thanks.
MD-E9000W
Check in the test mode � The spindle motor does not rotate.
Is waveform output from the pins 25 of IC1201 in the step 4 of AUTO auxiliary adjustment mode of TEST mode ? Yes Is waveform output from the pins 9 and 10 of IC1601 and the pins 5 and 6 of CN1401 ? Yes Replace with a spindle motor (complete). Check IC1601, CN1401, and soldering of mechanism switch PWB. No No Check the pins 25 of IC1201, soldering of peripheral circuit, and parts.
� The sled motor does not rotate.
Do the pins 23 of IC1201 change with the Yes Do the pins 14 and 15 of IC1601 and the pins 1 and 2 of CN1401 change with the / button ? Yes Does voltage of the + and - terminals on the sled motor change with the / button ? Yes Replace the sled motor. Check the soldering connected to the sled motor and for disconnection. Check IC1601 and soldering of CN1401. / button ? No Check the waveform of pins 23 of IC1201, peripheral parts, and soldering.
No
No
� 72 �
|
|
|
> |
|
