|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Complete manual with clear schematic diagrams and printed circuit board layouts of two variants of the headset and the transmitter an old and a new version.
Also shows how the headset and the transmitter is opened and how transmitter and receivers can be adjusted and where to measure.
I had no problems to repair the headset using this service manual.
 ;
Excellent printing quality. A complete and very useful manual with all details.
;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
;
Mi spiace per non poter scrivere in inglese... ma sono veramente soddisfatto del servizio offerto. Grazie..!!
;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
MD-MT877/MD-MT877C
OPERATION MANUAL
Using with the Rechargeable Battery
Charging
Do not force the battery cover open too far.
When the rechargeable battery is used for the first time or when you want to use it after a long period of disuse, be sure to charge it fully.
1 2
AC 120V 60Hz
Insert the rechargeable battery. Move the Charge/Operation switch to charge mode. Place the portable MD into the battery charger and connect the AC adaptor.
3
q After the rechargeable battery is charged or used, it will
Charge mode
get slightly warm. This is normal.
q When the portable MD is turned on or operating, the bat-
tery will not be charged.
To the DC IN 5V jack
Checking Displays
Checking the remaining amount of battery level
The remaining amount of battery level is shown by the battery indicator ( ) during operation.
How to read the battery indicator
When the battery level is high
When the battery low is very low
q When the battery is completely discharged, the battery
indicator will flash. Recharge the battery or replace the alkaline battery with a new one. q When the battery has run completely out, �BATT EMPTY (LoBATT)� will appear. Then, the power will be disconnected automatically. Notes: q If you use the battery which you stopped charging halfway, � � may appear. It does not mean that the battery is completely charged. q The battery indicator will not correctly display the remaining capacity for approximately 20 seconds after the power has been turned on. q When the AC adaptor or a separately available car adaptor is used, the battery indicator will not be shown. q The number of bars shown in the battery indicator may increase or decrease, depending on the operation being performed. This is normal.
�5�
|
|
|
> |
|
