|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
 ;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
;
Great copy of the manual, has all information required for servicing,
MD-MT877/MD-MT877C
OPERATION MANUAL
Using with the Rechargeable Battery
Charging
Do not force the battery cover open too far.
When the rechargeable battery is used for the first time or when you want to use it after a long period of disuse, be sure to charge it fully.
1 2
AC 120V 60Hz
Insert the rechargeable battery. Move the Charge/Operation switch to charge mode. Place the portable MD into the battery charger and connect the AC adaptor.
3
q After the rechargeable battery is charged or used, it will
Charge mode
get slightly warm. This is normal.
q When the portable MD is turned on or operating, the bat-
tery will not be charged.
To the DC IN 5V jack
Checking Displays
Checking the remaining amount of battery level
The remaining amount of battery level is shown by the battery indicator ( ) during operation.
How to read the battery indicator
When the battery level is high
When the battery low is very low
q When the battery is completely discharged, the battery
indicator will flash. Recharge the battery or replace the alkaline battery with a new one. q When the battery has run completely out, �BATT EMPTY (LoBATT)� will appear. Then, the power will be disconnected automatically. Notes: q If you use the battery which you stopped charging halfway, � � may appear. It does not mean that the battery is completely charged. q The battery indicator will not correctly display the remaining capacity for approximately 20 seconds after the power has been turned on. q When the AC adaptor or a separately available car adaptor is used, the battery indicator will not be shown. q The number of bars shown in the battery indicator may increase or decrease, depending on the operation being performed. This is normal.
�5�
|
|
|
> |
|
