|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent service manual, the only known point of note is the alignment of improvability scanned pages within the pdf page. The resolution is good.
;
I was very glad recieving the service manal from You. Additionaly very fast. Extremaly nice servicing. Thanks very mach! Now my GX-220 working better, than it was made. Alexander from Moscow, Russia/
;
Sweet! I won the item on eBay and couldn't adjust the geometry or even keep a steady picure. This guide has the full schematics (not available anywhere else as far as I could tell), and was a bargain for the wealth of knowledge it contains. I hooked it up to my testing equipment, tweaked a few potentiometers and got it playing videogames in no time. Thanks!
;
It was just what I need to fix my old BMW's CD player. Very convenient also. Thank you.
;
Great Manual! It contains all the wiring schematics and mechanical exploded views that are essential for service and repair. I was surprised I even found this for such an old machine. Only wish I knew of this site many years ago.
MD-MT80W/90W/90/90C
� The spindle motor fails to run. Does the head move
Does the waveform appear on the IC201 pins 24 and 25 after TEST mode AUTO2 completion and in this state? Yes
No
Check the IC201 periphery.
Does waveform appear on the IC601 pin 43? Yes Does waveform appear on IC901 pins 1, 2 and 23? Yes
No
Replace. IC601
No
L608, IC201, IC901, CN601 and flex, etc. soldering check
Replace the spindle motor.
� Recording/playback operation
Insert a low reflection disc, and ascertain audio output by normal playback, and then set TEST REC mode. Does the head move down, failing to start record even when the continuous record mode is set after address? No Does the RF waveform appear at TP201 (When monitoring the RF waveform, set to MSL:80H using the control setting item of EEPROM) when recording/Playback is performed No Does level of pins 86 of IC401 and pin 17 of IC101 change depending on record and playback? Yes Yes Yes Check voltage of pins 52 and 53 of IC201, pins 3, 4, 7, and 9 of IC651, pins 1 and 2 of CN601. Check whether disc is recordinhibited.
No
Check periphery of IC401 and IC101.
Is RF pattern output from IC201 pin 50? Yes Check whether there is any damage in IC101, periphery of laser diode. Check for defects of IC351 in head drive flexible PWB, head, flexible PWB.
No
Check for soldering failure of IC201 .
Is audio monitor output given in normal mode LINE IN record? No
Yes
Check waveforms of pins 8,10,11,12 of IC501, pins 70 to 73 of IC201.
Is waveform obtained on IC501 pins 2 and 3? No
Yes
Check whether the pin 13 of IC501 and the pin 59 of IC201 are in H state.
Is audio waveform observed on the pins 8 and 17 of IC703? Yes Check whether input waveform is observed on the pins 4 and 21 of IC703.
No
Does voltage on the IC701 pins 13 to 15 change in case of record VOLUME UP/DOWN?
� 41 �
|
|
|
> |
|
