|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
Editing Recorded MDs
3 4
Turn AMS until �Nm In ?� appears in the display, then press AMS. Turn AMS to select �Disc� to label an MD, or to specify the track to label, and press AMS. A flashing cursor appears in the display.
If you entered the wrong character
Press 0 or ) until the character to be corrected starts flashing, and repeat Steps 6 and 7 to enter the correct character.
To erase a character
Press 0 or ) until the character to be erased starts flashing, then press EDIT/NO.
To enter a space
Press AMS or ) while the cursor is flashing.
5
Press DISPLAY/CHAR to select the character type as follows: To select
Uppercase letters Lowercase letters Numbers
9
Press YES. This completes the labeling procedure and the title appears in the display.
Press DISPLAY/CHAR repeatedly until
�A� appears in the display �a� appears in the display �0� appears in the display
To cancel labeling
Press p. Note
You cannot label a track or an MD while you are recording over an existing track.
A
Copying a track or disc title 6
Turn AMS to select the character. The selected character flashes. Letters, numbers, and symbols appear in sequential order as you turn AMS. You can use the following symbols in titles: ! �#$%&�()*+,�./: ;<=>?@_` You can copy a track or disc title to use it as a title of another track or the disc title within a disc. Note that you can do this operation by using the controls on the deck only.
1 2 3 4
Press EDIT/NO. Turn AMS until �Name ?� appears in the display and press AMS. Turn AMS until �Nm Copy ?� appears in the display. Press AMS. Turn AMS to select �Disc� to copy the disc title, or the track whose title you want to copy and press AMS.
D
You can press DISPLAY/CHAR to change the character type at any time during Step 6 (see Step 5).
5
7
Press AMS to enter the selected character. The cursor shifts rightward and waits for the input of the next character.
If �No Name� appears in the display
The disc or the track has no name.
6
D
Turn AMS to select �Disc� for disc title or to specify the track number to copy a title, and press AMS. �Complete!!� appears for a few seconds to indicate that the copying operation is completed.
8
Repeat Steps 6 and 7 until you have entered the entire title.
To cancel title copying
Press EDIT/NO or p.
34EN
|
|
|
> |
|
