|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank you very much for the manual. It is what I needed and it will be very helpful to me. The delivery of the manual was easy and very fast. I strongly recommend this site to other users. Best regards.
 ;
Excellent!! Got what I need and very fast!! Thank You
;
Manual acquired with good resolution, complete in all its pages, very good policy of the folder where are saved all products purchased.
;
Service manual very complete and clear. It was very helpfull for my work.
;
This is the 2nd time I download manuals from this website and I can say it's what I was expecting. It contains schematic, layout (decent quality), short description, parts and dissasembly instructions. I recomend it for anyone who wants to repair/modify this device.
ATTACHING THE GLASS ASSEMBLY
� Attach according to steps 1 to 4.
1
2 1
4 Screw (PTP2.6x6) 3 Bracket (shaft)
(Bottom side) When fixing this part, secure at the center to allow for some play. Open and close the glass window several times, and check that the parts do not touch each other.
FLUORESCENT INDICATOR TUBE, LED COMPLETE LIGHTING CHECK
� The fluorescent indicator tube and LED complete lighting and key check mode of this unit can be performed as follows. Procedure: 1. While pressing the ENTER/YES and rREC buttons, insert the power plug into the outlet, and turn ON the power. 2. �FL All On Key� will be displayed momentarily, after which immediately the fluorescent indicator tube and LED will light up completely. 3. The fluorescent display tube will go off part by part each time a button is pressed. When all buttons have been pressed, �Push Yen� will be displayed. 4. When the ENTER/YES button is pressed next, �Seg Chk� will be displayed momentarily. 5. Checkered pattern will be displayed on the fluorescent display tube. 6. When the ENTER/YES button is pressed next, �Jog & LED Chk� will be displayed. 7. The LED lighting state changes each time the � � + knob is rotated. (The LED will stop reacting after the knob has been rotated to some extent. This is not a fault.) 8. When the ENTER/YES button is pressed, �Check End� will be displayed on the fluorescent indicator tube, and the check mode ends.
� 11 �
|
|
|
> |
|
