|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good manual. Plenty of service information including alignment instructions. Clear circuit diagram. Excellent, thank you.
 ;
Good morning, the service manual you sent me was perfect.
Your service and answering are excellent.
I recomend this service.
Best regards.
;
I had been looking everywhere for a proper service manual for this VCR. Everywhere else that has this available for download has a very light version. This is the full service manual with all aspects that would interest anyone looking for the service manual for the AIWA HV-MX100 Worldwide VHS VCR. Great quality (as always). A winner hands down. Best Quality.
;
Top quality manual. Covers all aspects you'd expect in a top quality service manual for this Panasonic VHS VCR. The manual resolution is high. Another top quality manual from the only site worth downloading manuals from! If you're looking for a manual for the PV-9662 VHS VCR, this is the one you'll want to get!
;
complete part-lists and pcb layout, schematic diagram is good enlargable,
SECTION 3 ELECTRICAL ADJUSTMENTS
TEST MODE This set have the test mode function. In the test mode, FM Auto Scan/Stop Level and AM Auto Scan/Stop Level adjustments can be performed easier than it in ordinary procedure. <Set the Test Mode> 1. Turn ON the regulated power supply. (All LEDs on the set lights up, and the clock is displayed.)
TUNER SECTION
0 dB=1 µV
Cautions during repair When the tuner unit is defective, replace it by a new one because its internal block is difficult to repair.
Note: Adjust the tuner section in the sequence shown below.
[OFF] button, if the clock is not displayed. 2. Push the preset [4] button. 3. Push the preset [5] button. 4. Press the preset [1] button for more than two seconds.
5. Then the display indicates all lights, the test mode is set. <Release the Test mode> 1. Push the [OFF] button. See the adjustment location from on page 17 for the adjustment.
Note: Press the
1. FM Auto Scan/Stop Level Adjustment 2. FM Stereo Separation Adjustment (Wide)
3. FM Stereo Separation Adjustment (Narrow) 4. AM Auto Scan/Stop Level Adjustment FM Auto Scan/Stop Level Adjustment Setting:
[SOURCE] button : FM
FM RF signal generator
antenna jack (CN101) 0.01 µF
MD SECTION
MD section adjustments are done automatically in this set.
Carrier frequency Output level Mode Modulation
set : 98.00 MHz : 22 dB (12.6 µV) : mono : 1 kHz, 22.5 kHz deviation (30%)
Procedure: 1. Set to the test mode. 2. Push the [SOURCE] button and set to FM. Display
SHUF
3. Adjust the volume RV2 on TU101 by turning clockwise untill �0� is shown next to �FM� on the display window, If �0� is already shown or the volume RV2 has been turned too far, turn it back counterclockwise untill �0� is disappeared once, then try this adjustment. Display
SHUF
Adjustment Location: See page 17.
15
|
|
|
> |
|
