|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Product was very good. Received quickly and complete
 ;
Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
To erase a preset station
1 Press and hold TUNER MEMORY until a preset number appears in the display.
Saving the power in standby mode
(MHC-BX3 only)
You can lower the power consumption to a minimum (Power Saving Mode) and save energy in the standby mode.
?/1 (Power) DISPLAY
2 Turn the shuttle until it clicks to select the preset number you want to erase. Select �ALL ERASE� when you want to erase all the preset stations. 3 Press ENTER. �COMPLETE� appears. When you erase a preset number, the preset number decreases by one and all preset numbers following the erased one are renumbered.
To change the AM tuning interval
(Except for the European and Middle Eastern models)
The AM tuning interval is factory-preset to 9 kHz (10 kHz in some areas). To switch the AM tuning interval, tune in any AM station first, then turn off the power. While holding down ENTER, turn the power back on. When you change the interval, AM preset stations are erased. To switch back to the original interval, repeat the same procedure.
Tip
The preset stations are retained for half a day even if you unplug the power cord or a power failure occurs.
, Press DISPLAY repeatedly when the power is off. Every time you press the button, the system switches as follows:
t Demonstration t Clock Power Saving Mode T The system is turned on/off by pressing ?/1.
Tips
� ?/1 indicator and timer indicator (when the timer is set) light even in the Power Saving Mode. � The timer functions in the Power Saving Mode.
Note
You cannot set the time in the Power Saving Mode.
To cancel the Power Saving Mode
Press DISPLAY once to show the demonstration, twice to show the clock display.
9
 $4.99 MHCBX3 SONY
Service Manual Complete service manual in digital format (PDF File). Service manuals usually contains circuit diagr…
|
|
|
> |
|
