SONY MHC-ZX10
Owner's Manual

To tune in a station with a weak signal
Press m or M repeatedly in step 2 to tune in the station manually.

To change the AM tuning interval (Except for the European model)
The AM tuning interval is factory-preset to 9 kHz (10 kHz in some areas). To switch the AM tuning interval, tune in any AM station first, then turn off the power. While holding down MODE SELECT, turn the power back on. When you switch the interval, AM preset stations are erased. To switch back to the original interval, repeat the same procedure.

Getting Started

To set another station to an existing preset number
Start over from step 1. After step 5, press . or > to select the preset number where you want to store the other station, then press PUSH ENTER. You can preset a new station in the selected preset number.

To erase a preset station
1 Press TUNER/BAND to select FM or AM. 2 Press MODE SELECT repeatedly to select �Set Up Mode�, then press PUSH ENTER. 3 Move the multi stick toward b or B repeatedly to select �TUNER Set Up ?�, then press PUSH ENTER. 4 Move the multi stick toward b or B repeatedly to select �TUNER Erase ?�, then press PUSH ENTER. 5 Move the multi stick toward b or B repeatedly to select the preset number you want to erase, then press PUSH ENTER. Select �TUNER Ers FM ALL� (or �TUNER Ers AM ALL�) when you want to erase all the preset stations. When you erase a preset number, the preset number decreases by one and all preset numbers following the erased one are renumbered. Tip
The preset stations are retained for half a day even if you unplug the power cord or a power failure occurs.

9