|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Superb! It's the original manual. We can now use our old calculator with its full function.
;
This is a very well written and comprehensive manual. It answered all our queries.
;
Excellent copy that was delivered within 12 hours and solved my problem.
 ;
I did not have the manual for a Whirl Pool gas dryer, therefore I purchased it from Owner-manuals. This is exactly what I needed. Thank you for the service.
;
I was so pleased to get the owner`s manuel within one hour! Thanks again.
Regards
Werner
p.-
INSTALLATION INSTRUCTIONS PART NO. 21 0777
Microwave Oven Built-In Kit
Models MK27 and MK30
i [] 'JENN-AIR
3035SHADELAND-tNDIANAPOLIS. tN46226-0901 J
With use of Model M16g Microwave oven.
Step 1. Electrical
OBSERVE
Requirements
CODES AND ORDINANCES.
ALL GOVERNING
A. A 120-Volt, 60Hz, AC, 15 ampere, fused electrical supply is required (time-delay fuse or circuitbreaker is recommended.) However, if your home has a circuit wired and fused for 20 amperes, this is preferred. If you are installing a new circuit, one wired and fused for 20 amperes is recommended. It is also recommended that a separate circuit serving only this appliance be provided. Do not use an extension cord. B. Electrical Connection ELECTRICAL GROUND IS REQUIRED ON THIS APPLIANCE. DO NOT, UNDER ANY CIRCUMSTANCES, REMOVE THE POWER SUPPLY CORD GROUND PRONG. For your personal safety, this appliance must be preperly grounded and polarized. This appliance is equipped with a power supply cord having a 3-prong grounding plug. To minimize possible shock hazard, the cord must be plugged into a mating 3-hole grounding type wall receptacle, grounded in accordance with the National Electrical Code, local codes and ordinances. If a mating wall receptacle is not available, it is the personal responsibility and obligation of the customer to have a properly grounded and polarized 3-hole wall receptacle installed by a qualified electrician. (See Figure 1.) Note: A 27" minimum widecabinetmustbe provided to install TrimKitMK27. Note: A30" minimum widecabinet ust e providedo mb t install rimKitMK30. T
_
Step 2. Bottom
Rail
A. Set microwave on its back so bottom is accessible. R, move left outboard screw and corresponding righthar screw from bottom front and attach bottom rail as shov in Figure 2 with same screws.
3-Prong Grounding Plug
PowerSupply1
i
"
'_'_
Propedy PolarJz_l 3-HoteGrounding
� :_"
Fig.
1
Type WaltReceptacle Required Grounding Method Fig. 2
|
|
|
> |
|
