|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
have download a number of manuals todate , most are excellant, one or two sometimes a little difficult to read but a least avaialable, great site .
Brad.
;
Excellent had everything I wanted, very happy with purchase
 ;
This service is relatively cheap, document is fast available, schematic is readable.
Thanks.
;
So far I´m a satisfied customer. I have only downloaded "TECHNICS SX-KN470 Service Manual" maybe I will use it later.
Best regards
Peter
;
Good manual. It is complete and of high quality, both text and graphics. The schematics are with the original big size, so it can be viewed or printed without any loss of resulution and sharpness.
Precautions
1-4 Special Precautions and Warning Labels for Laser Products (Continued)
1-4-1 Warnings 1. When servicing, do not approach the LASER exit with the eye too closely. In case it is necessary to confirm LASER beam emission, be sure to observe from a distance of more than 30 cm from the surface of the objective lens on the optical pick-up block. 2. Do not attempt to handle the objective lens when the DISC is not on the tray. 1-4-2 Laser Diode Specifications Material: GaAs+ GaAlAs Wavelength: 760-800 nm Emission Duration: Continuous Laser Output: 0.2 mw (measured at a 1.6 mm distance from the objective lens surface on the optical pick-up block.) 1-4-3 Handling the Optical Pick-up 1. Static electricity from clothing or the body may cause electrostatic breakdown of the laser diode in the Optical Pickup. Follow this procedure: 2. Place a conductive sheet on the work bench (i.e., the black sheet used for wrapping repair parts.) Note: The surface of the work bench should be covered by a copper ground plane, which is grounded. 3. The repair technician must wear a wrist strap which is grounded to the copper sheet. 4. To remove the Optical Pickup block: Place the set on the conductive sheet, and momentarily touch the conductive sheet with both hands. (While working, do not allow any electrostatic sources--such as clothes--to touch the unit.) 5. Ground the "Short Terminal" (located on the PCB, inside the Pickup Assembly) before replacing the Pickup. This terminal should be shorted whenever the Pickup Assembly is lifted or moved. 6. After replacing the Pickup, reopen the Short Terminal. See diagrams below:
1M
THE UNIT
(1) WRIST-STRAP FOR GROUNDING
CONDUCTIVE SHEET 1M
short terminal
short terminal
short terminal
short terminal
SOH91VI(LDP)
SOH91CI(CAR,walkman)
SOH-A1 (CMS-V10,CMS-V30)
SOH94T4N (CMS-V10,CMS-V30)
1-4
Samsung Electronics
|
|
|
> |
|
