ROLAND MMP-2
Owner's Manual

Top and Rear Panels

These adjust the [MIC IN] sensitivity. (p. 17) 10. [PEAK] Indicators These light up when the input level exceeds the set value. (p. 17) 11. [PHANTOM/PHASE/LO-CUT] Buttons These call up the Phantom power switches, plus the Phase, Lo-cut, and Attenuator setting screens. (p. 17) 12. [EDIT CH SELECT] Buttons These specify the channels to manipulate. Pressing them simultaneously links the effect settings for both channels. (�Linking� (p. 28)). 13. [BYPASS] Buttons These bypass effects temporarily. (p. 19) 14. [EDIT SELECT] Buttons ([MODEL] Button) This calls up the editing screen for microphone modeling. (p. 19) 15. [EDIT SELECT] Buttons ([EQ] Button) This calls up the parameter screen for the equalizer. (p. 20) 16. [EDIT SELECT] Buttons ([DYNAMICS] Button) This calls up the parameter screen for dynamic effects. (p. 21) 17. [EDIT SELECT] Buttons ([PLUG IN] Button) This calls up the editing screen for plug-in effects. (p. 24)

Rear Panel

1
1. 2. 3. 4. 5. 6. 7. 8. [POWER] Switch

2

3

45

6

7

8

This switches the power on and off. (p. 13) [AC IN] Connector This is for connecting the power cable. (p. 12) [DIGITAL OUT AES/EBU] Jack This is an AES/EBU-standard digital-output jack. [DIGITAL OUT] Jack This is an S/PDIF-standard digital-output jack. [DIGITAL IN] Jack This is an S/PDIF-standard digital-input jack. [USB] Jack This is for connecting a computer and exchanging parameter settings using MIDI protocol. (p. 30) [OUTPUT LEVEL] Switch This switches the output level to either -16 dBu or +4 dBu. (p. 13) [LINE OUT] Jack This is a balanced XLR-type line-output jack. (p. 13)

10