|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Product was very good. Received quickly and complete
 ;
Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
Hardware Setup
Front Panel Features The front panel of the MobilePre USB houses features providing the following functions: 1. Channel 1 Inst/Line Input Jack: This 1/4� balanced connector
accepts an instrument or line level signal for Channel 1 of the MobilePre USB. This input is ideal for recording guitar, bass or synthesizer. If you are recording a stereo line-level source, plug the left channel into Line Input 1 (on the front panel of the MobilePre USB) and the right channel into Line Input 2 (on the rear panel). 2. Channel 1 Gain Knob: This control knob regulates the level of the signal going from the Channel 1 Mic or Line input to your computer. 3. Channel 1 Level LEDs: These two LEDs show signal present and clipping of Channel 1 of the MobilePre USB.You should adjust the Gain control so that the signal present is on as much as possible but the Clip LED does not come on. 4. Channel 2 Gain Knob: This control knob regulates the level of the signal going from the Channel 2 Mic or Line input to your computer. 5. Channel 2 Level Meter: These two LEDs show when input signal into Channel 2 is present or clipping.You should adjust the Gain control so that the signal present is as high as possible without lighting the the Clip LED. 6. Headphone Output Jack: This 1/8� stereo jack plays back outputs 1 and 2 through the Left and Right speakers of your headphones. 7. Headphone Level Knob: This knob controls the level to the Headphone Out 8. Phantom Power Switch: Press this switch button into the In-position to send voltage to microphones which require phantom power and are connected to XLR Mic Inputs 1 and 2. 9. Phantom Power Indicator: This LED lights when phantom power is switched on. 10.Power Indicator: This LED indicator lights when the MobilePre USB is receiving power through its USB port.
18
|
|
|
> |
|
