|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
helpful manual.good service.Quick response.will use again
 ;
Speedy confirmation to my order , with elaborate instructions .
Item Email , received immediately as desired by me.
A Pleasant & Satisfying Transaction.
;
I was searching for this manual at last i got it from this web
;
What can i say but i would have been lost without your support.
Thank You!
;
Très satisfait ! envoi rapide, Grand catalogue disponible. Many thanks !
Please note the color order The colors of the jacks on the DVD Recorder must match those on the TV (red-red/blue-blue/green-green). If they are not matched properly, this could cause the color of the picture to be reversed or there could be no picture at all.
Tip
5 6 7 8
Connect audio cables to the AUDIO OUT jacks at the back of the DVD Recorder (next to COMPONENT VIDEO Y PB PR OUT ) and to the red/white Audio In jacks of the TV (usually called Audio in', 'AV in', please see your TV's instruction manual). Switch on the TV. If necessary, set the TV to the Component Video channel. If necessary, see the operating instructions for your TV. Or, go to channel zero on your TV, then keep changing channels down until you see the DVD Recorder screens (when the Recorder is on). This is not channel 3 or 4 as it would be if you used only the RF coaxial cable connection. Connect the supplied power cable to the mains jack 4MAINS at the back of the DVD Recorder and to a power supply. The most important features of the DVD Recorder will appear on the display. After the initial installation is completed, this function will be switched off. To switch on this function again, read in the section 'Standby' in the chapter 'User preferences'. Press STANDBY-ON m on the recorder. 'IS TV ON?' will appear on the display. Then, read 'Initial installation' in the chapter 'Installing your DVD recorder'.
Switching TV and DVD Recorder to 'Progressive scan' The factory settings of the DVD Recorder are set to 'Interlaced'. If you selected the 'Progressive scan' connection during installation, you must switch the 'Component Video output' of the DVD Recorder and, if necessary, the 'Component Video input' of the TV to 'Progressive scan.' Switching the TV Please select 'Progressive scan' for the Component Video input on the TV. If necessary, see your TV instruction manual. If your TV is equipped with separate input jacks for Interlaced and Progressive, connect the DVD Recorder to the jack that supports 'Progressive scan.' Switching the DVD Recorder 1 Disconnect the recorder's power cord. 2 Hold down N on the front of the DVD Recorder while reconnecting the power cord. 'PRO' (progressive scan) will appear on the display. 3 If you want to switch back, repeat steps 1 and 2 . 'PRO' (progressive scan) will disappear from the display. The DVD Recorder is switched to 'Interlaced.'
Tip
12
Connecting the DVD Recorder
|
|
|
> |
|
