INFINITY MS-1
Owner's Manual

CONNECTIONS
Turn Off All Power
After placing the speakers, you are ready to connect your system. First, turn off all audio-system power. Use high-quality speaker wire to make your connections. Use at least #16-gauge speaker wire with polarity coding.The side of the wire with a ridge or other coding is usually considered positive polarity (i.e., + ). Also, consult the owner�s manuals that were included with your amplifier or receiver to confirm connection procedures.

MAINTENANCE AND SERVICE
The speaker enclosures may be cleaned using a soft cloth, dampened with water only, to remove fingerprints or to wipe off dust. The grilles may be gently vacuumed. Do not use any solvents on the grille. All wiring connections should be inspected and cleaned or remade periodically.The frequency of maintenance depends on the metals involved in the connections, atmospheric conditions, and other factors, but once per year is the minimum. If a problem occurs, make sure that all connections are properly made and clean. If a problem exists in one loudspeaker, reverse the connection wires to the left and right system. If the problem remains in the same speaker, then the fault is with the loudspeaker. If the problem appears in the opposite speaker, the cause is in another component or cable. In the event that your Modulus loudspeakers ever need service, contact your local Infinity dealer or Infinity directly at 1-800-553-3332 or www.infinitysystems.com for a service center near you.

Important!
Do not reverse polarities (i.e., + to � or � to +) when making connections. Doing so will cause poor imaging and diminished bass response. Be certain that positive and negative wire strands are completely isolated to avoid short circuits that may damage your equipment.

FIGURE 10 � Wiring diagram shows polarity connections for one
channel of a stereo or home theater system.

6

MODULUS MS-1