Turns out this was not the manual i was looking for. The concertmate 670 keyboard i have is a "Realistic" model made for Radio Shack and none of the diagrams on the owners manual i received matches up. HOWEVER, I must say the service Owners Manual provides was fast and efficient by being available online. The manual was in good readable condition and easily downloaded.
Thank´s for your help, I already recived these manual from you
Text excerpt from page 12 (click to view)
CLEANING THE OVEN
Glass Panel
This should be cleaned with a soft cloth soaked in warm detergent water. Do not use abrasive scourers or steel wool.
Removing/Replacing The Oven Door
(Fig. 10)
Oven Shelves
To clean the chrome parts of the oven, soak in warm detergent water and remove stubborn marks with a well wetted soap impregnated pad. Rinse well and dry with a soft cloth.
30°
Oven Cavity
The enamelled oven cavity is best cleaned whilst the oven is still warm. It is preferable/advisable to wipe the oven over with a soft cloth soaked in warm detergent water after each use. However, from time to time it will be necessary to do a more thorough cleaning, using a proprietary oven cleaner.
FO 0452
Fig. 10
Replacing Components
Prior to undertaking any maintenance work or replacing the oven light, be sure to disconnect appliance from the electricity supply.
Warning:
It is important that the retaining discs are fully turned and located as the hinges are under high sprung tension. 1. Open the door completely so that it is in the horizontal position. 2. Raise the two bars. 3. Raise the door halfway. 4. At this stage clasp the two hinges on either side of the door together simultaneously. The door can then be removed by pulling out and downwards, maintaining the angle.
Replacing The Oven Light
Push in and turn the glass lid anticlockwise (Fig. 9). Remove the faulty bulb and replace with one which is heat resistant to 300°C).
To Replace The Door
1. Clasp the two hinges on either side of the door together simultaneously. 2. Hook the top hinge into the top slot, so that the hook is engaged with the roller. 3. Drop the lower hinge into the lower slot, so that the notch is engaged. Drop the door down so it is in the horizontal position.
FO 0287
Fig. 9
Note
It is important when carrying out this operation that both hinges be located simultaneously. 4. Turn the bars. The door can then be closed.
Electric bulb: 15W, 220-240 V, 50 Hz, 300°C, E14. These bulbs are available from your local Moffat Service Centre.
