|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
;
This manual is very well presented and after printing out looks about as close to an original as I think you can get. The quality is second to none.
The content of the manual is comprehensive and I think it would be well suited to an audio repair professional which I'm not but I did find it very informative and helpful.
The cost of the manual is more than covered by the money I'll save when I change the keep memory battery now I have the relavant info.
Very pleased with my purchase and can recommend it wholeheartedly as I can other manuals I've downloaded from this site.
Regards
Limey Alex
 ;
Complete manual including mechanical part in good pdf quality. Shaded greys of the pcb due to pdf not perfect but usable.
;
Nice pdf file of the manual sent promptly. Thanks.
;
Complete MFG Service Manual at a good price FAST !
CHAPTER 5 TROUBLESHOOTING
2. Detecting by the Bin Inside Paper Sensor Perform this check when following parts are replaced. � Paper sensor in bin unit (PS1, PS2) Procedure 1) Remove all the paper from the bin unit. 2) Detach the rear cover and set the dip switch (SW3) on the sorter controller PCB as shown below.
*
ON
123456
Figure 5-101 * The No.6 switch is used for switching the communication system with the copier and should not be moved. 3) Put copy paper in the bin, and check the condition of the Manual Staple key: It should turn on to indicate the presence of paper, and It should remain off to indicate the absence of paper. 4) If the Manual Staple key does not operate as expected, check to see if the bin inside paper sensor (light-emitting side, light-receiving side) is mounted correctly, and check the activation of the sensor once again. 5) Thereafter, shift the bits of the DIP switch (SW3) on the sorter controller PCB to their original positions.
5-2
COPYRIGHT © 1998 CANON INC. CANON STAPLER SOTRER-L1 MS-C1 REV.0 NOV. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
|
|
|
> |
|
