|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I am only search for 5 Minute, by it in 5 Minutes to and get ist in few ours! Best i found in the Internet and my Amplifer is repaired as well! Thank you
 ;
Readable text and good copy. Very much needed if you wish to do some repairs on this fine old unit.
;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
DELETING (OR ADDING) CHANNEL
TV
The channels you no longer receive or seldom watch can be deleted from the memory. (Of course, you can add the deleted channel into the memory again.)
1
Select �CHANNEL SET UP�
- TV SETUP B CHANNEL SET UP V-CHIP SET UP LANGUAGE [ENGLISH] CAPTION [OFF]
Press SETUP on the remote control. Press Arrow (K/L) to point to �CHANNEL SET UP�. Then, press ENTER.
2
Select �ADD/DELETE CH�
� CHANNEL SET UP � B ADD / DELETE CH (CATV) AUTO CH PROGRAMMING
Press Arrow (K/L) to point to �ADD/DELETE CH�. Press ENTER.
3
Enter the desired channel number
Press Arrow (K/L) until your desired channel number appears. (You can also use the number but08 tons or CHANNEL(CH.) K/L to enter it) (Example: CH8) � You must proceed single-digit channel numbers with a zero (Example: 02 ... 09). � When selecting cable channels which are higher than 99, press +100 first, then, press the last two digits. (Example: to select channel 125, first press +100, then press 2 and 5).
ADD / DELETE
4
Delete (or add) it from (into) memory
Press ENTER. The channel number changes to light red. The channel is deleted from memory. � To delete another channel, repeat steps [3] and [4]. � If you press ENTER again, the channel is memorized again. Added channel: Light blue. Deleted channel: Light red.
5
Exit the channel setup mode
Press SETUP to return to TV mode. NOTE: To confirm that channel(s) has been deleted or added, press CHANNEL(CH.) K/L.
� 14 �
0C28
EN
|
|
|
> |
|
