|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
Section 1 Service Overview
1-1. Self-Diagnosis
Operation of the switches, LED indicators, and rotary encoders on the control panel can be checked by the self-diagnosis mode of the unit. Preparations 1. Press [PANEL|ACTIVE], [PARA], and SCENE FILES [1] switches at the same time. Operation check Switch with LED When the desired switch is pressed, the LED inside the switch lights up. And when the buzzer ON/OFF switch S6 on the CPU-293 board is in ON position, the buzzer beeps at the same time. To turn off the LED, press switch again. (Avoid lighting all the switches simultaneously for a relatively long period of time.) Indicator 1. Camera number/Tally display block Make sure that a red and green cross indication moves from the right to left.
Red
Green
2. Make sure that the CARD ACCESS indicator blinks in sequence of red, green then orange. 3. Make sure that the MULTI, TALLY, and PANEL ACTIVE indicators of the camera selector block blink in sequence of red, green then off. 4. Make sure that the EXT indicator of the IRIS adjusting block blinks. 5. Make sure that the 7-segment LEDs of ECS/SHUTTER, GAMMA, MASTER GAIN control blocks and MASTER BLACK and IRIS adjusting blocks light up in the following order.
1 67 5 4 2 3 8
Rotary encoder When the desired rotary encoder has been turned, the ID number corresponded with the rotary encoder will be displayed on the IRIS adjusting block, and the control value is displayed on the MASTER BLACK adjusting block.
MSU-700A MMP2
1-1 (E)
|
|
|
> |
|
