The service manual when downloaded and printed out was clear and easy to read. The manual is complete with the schematic diagram and technical data. I occasionally require a manual and now having registered with this company I shall order from them in the future.
Hello from Germany - thank you very much for the manual for my Sharp "Searcher" - the handling of your internet area is outstanding..Mike
Text excerpt from page 15 (click to view)
Building-in instructions
Before carrying out any work, remove the plug from the power socket.
Installation kit
1xB 2xC
Grid preparation
Left door opening: Remove the left side (A) of the grid cutting it from the rear (see figure).
A B
1xA
2xG 2xL 2xF 2xD
1xK
18xI
2xE
Right door opening: Remove the right side (B) of the grid cutting it from the rear (see figure). To position the grid on the appliance proceed as follows: Apply the grid to the base of the appliance by pushing on to the clasps (a) until they click.
600
DO002/2
1. Two cabinet securing brackets are supplied with the installation pack. They need to be assembled onto the cabinet prior to cabinet being pushed into the Kitchen aperture. - To fit these brackets remove the two screws at the top left and right hand front corners of the cabinet. - Position the two brackets as shown in the figure and replace the two securing screws.
55 min0 .
600
DO013
Building in the appliance under a worktop
The dimensions of the recessed installation area must correspond with those indicated in the figure.
a
