|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
 ;
Immediate response with excellent service - highly reccommended
 ;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
 ;
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
 ;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
3.
Use the numeric keypad to enter the time that you want to poll the other fax. t Set the time using the 24-hour system. If the hour or minute is a single digit, precede it with a zero. For example: 07:30 = 7:30 a.m. 17:05 = 5:05 p.m. t If you make an error entering the time, press CLEAR. Then enter the correct time.
4.
Press START/COPY.
TEL=
5.
Dial the fax number(s) you want to poll. t You can poll up to 97 destinations. See page 10-1 for details.
6.
Press START/COPY.
POLLING TX/RX NO.
XXXX
The LCD displays:
06/21/95 TIMER 17:10
Your MultiPASS 1000 begins receiving the document at the preset time. t t The MultiPASS 1000 beeps once when the document is received without errors. The MultiPASS 1000 automatically redials if the other fax does not answer or if the line is busy. (You can specify the number of times it redials; see Auto Redial on page 5-17.) If an error occurs during reception, the MultiPASS 1000 beeps intermittently for a few seconds. If this happens, try polling again. To stop polling while receiving, press STOP. If the ALARM light is flashing, clear the error and press STOP. If necessary, refer to Chapter 14, Troubleshooting. Chapter 10
t
t t
10-20 Special Sending Procedures
|
|
 |
> |
|