TOSHIBA MV20FL4
Service Manual

DISASSEMBLY INSTRUCTIONS
2-6: LINK UNIT (Refer to Fig. 2-6) 1. Set the Link Unit to the Eject position. 2. Remove the (A) side of the Link Unit first, then remove the (B) side. 2-9: TENSION ASS'Y (Refer to Fig. 2-9-B) 1. Turn the Middle Gear clockwise so that the Tension Holder hook, is set to the position of Fig. 2-9-A to more the Tension Arm Ass'y. 2. Remove the Tension Spring. 3. Unlock the support 1 and remove the Tension Arm Ass'y. 4. Remove the Tension Adjust. 5. Unlock the 2 supports 2 and remove the Tension Band Ass'y. 6. Float the hook 3 and turn it clockwise then remove the Tension Holder. 7. Remove the SS Brake Spring. 8. Remove the SS Arm Brake.
Tension Arm Ass'y

Link Unit

(B) (A) Link Unit

Main Chassis

Main Chassis

Fig. 2-6

2-7: LOADING MOTOR ASS'Y (Refer to Fig. 2-7) 1. Remove the Link Lever. 2. Remove the screw 1. 3. Remove the Loading Motor Ass'y. 4. Unlock the 2 supports 2 and remove the Deck PCB (BOT). Fig. 2-9-A
Tension Adjust

2 2

Tension Band Ass'y

Loading Motor Ass'y Tension Spring Tension Arm Ass'y

2
SS Brake Spring Main Chassis

1 3

Tension Holder

1
Deck PCB (BOT) Link Lever

SS Arm Brake Inclined S Ass'y

Fig. 2-9-B
� Screw Torque: 5 ± 0.5kgf�cm

Fig. 2-7

NOTE When you install the Tension Adjust, install as shown in Fig. 2-9-C. (Refer to Fig. 2-9-C)
Adjust the direction of the Marker to inside.

2-8: SENSOR COVER L3 (Refer to Fig. 2-8) 1. Unlock the support 1 and remove the Sensor Cover L3.

Main Chassis

Fig. 2-9-C
Sensor Cover L3

1

Fig. 2-8