|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
muy buen manual por lo completo de este algunos esquemas estan muy divididos lo que hace algo dificil el seguimiento.
;
very good manual, with detail and clarity in esquematic diagrams and waveforms .
 ;
Very quality copy of original service manual, which contains the circuit diagrams, PCB and lists of components, well as recommendation for calibration procedures of device, also everything else, that need for repair, tuning and use this oscilloscope.
All presented copies have high-resolution, so you can view all in detail.
This manual will very useful for simple owners and for repairers.
I recommend these manual, because myself is owner of Philips PM3216 and I need sometimes servicing these oscilloscope (principally calibrating).
Also, these document is an example of excellent design of technical documentation.
;
Excellent printing quality.
A complete and very usefull service manual with all details.
GREAT SERVICE AT VERY LOW PRICE!
A+++++++++++++++++++++++++
;
manual excelente completo , diagramas y esquemas bien presentados y buena calidad de imagen.
DISASSEMBLY INSTRUCTIONS
2-5: LOADING MOTOR/WORM (Refer to Fig. 2-5-A) 1. Remove the screw 1. 2. Remove the Loading Motor. 3. Remove the Worm. 2-6: TENSION ASS�Y (Refer to Fig. 2-6-B) 1. Turn the Pinch Roller Cam clockwise so that the Tension Holder hook is set to the position of Fig. 2-6-A to move the Tension Arm Ass�y. 2. Remove the Tension Spring. 3. Unlock the 2 supports 1 and remove the Tension Band. 4. Unlock the support 2 and remove the Tension Arm Ass�y. 5. Unlock the support 3 and remove the Tension Connect. 6. Float the hook 4 and turn it clockwise then remove the Tension Holder.
Worm Tension Arm Ass�y Main Chassis
Loading Motor
� Screw Torque: 3 ± 0.5kgf�cm
1
Fig. 2-5-A
1
Tension Connect
Fig. 2-6-A
NOTE 1. In case of the Worm installation, check if the value of the Fig. 2-5-B is correct. 2. In case of the Loading Motor installation, slacken the wire as shown Fig. 2-5-C. 3. When installing the wires between Capstan DD Unit and Loading Motor, connect them correctly as shown Fig. 2-5D.
2 4
19.2 ± 0.1mm
1 3
Tension Band
Tension Spring Tension Holder
Tension Arm Ass�y
Fig. 2-6-B
Safety surface for pressing of the insert.
NOTE Fig. 2-5-B 1. In case of the Tension Band installation, note the direction of the installation. (Refer to Fig. 2-6-C) 2. In case of the Tension Band installation, install correctly as Fig. 2-6-D. 3. In case of the Tension Connect installation, install as the circled section of Fig. 2-6-E.
Slacken the wire.
Loading Motor
Fig. 2-5-C
Tension Connect
Tension Band
Pink Loading Motor Capstan DD Unit L2
Fig. 2-6-C
+
L1
White
Fig. 2-5-D
B2-2
|
|
|
> |
|
