|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent service manual, the only known point of note is the alignment of improvability scanned pages within the pdf page. The resolution is good.
 ;
I was very glad recieving the service manal from You. Additionaly very fast. Extremaly nice servicing. Thanks very mach! Now my GX-220 working better, than it was made. Alexander from Moscow, Russia/
 ;
Sweet! I won the item on eBay and couldn't adjust the geometry or even keep a steady picure. This guide has the full schematics (not available anywhere else as far as I could tell), and was a bargain for the wealth of knowledge it contains. I hooked it up to my testing equipment, tweaked a few potentiometers and got it playing videogames in no time. Thanks!
 ;
It was just what I need to fix my old BMW's CD player. Very convenient also. Thank you.
 ;
Great Manual! It contains all the wiring schematics and mechanical exploded views that are essential for service and repair. I was surprised I even found this for such an old machine. Only wish I knew of this site many years ago.
DISASSEMBLY INSTRUCTIONS
1-5: TOP SHIELD ASS'Y (Refer to Fig. 1-5) 1. Remove the 9 screws 1. 2. Remove the Top Shield Ass'y in the direction of arrow.
4 1
Top Shield Ass'y CD Deck Pick Up PCB
4
1 1 1 1 1 1 1 1
Operation PCB
4 4 3 1 1
(D) Angle Deck Make the short circuit 1 using a soldering.
3
Front Shield
(C)
1
(B) (E) DVD PCB
2 2 5 5 5 5
(A) DVD/VCR Block
Fig. 1-5 Fig. 1-6 1-6: OPERATION PCB/DVD PCB/CD DECK (Refer to Fig. 1-6) 1. Make the short circuit on the position as shown Fig. 1-6 using a soldering. If you remove the Deck CD with no soldering, the Laser may be damaged. 2. Disconnect the following connectors: (CP2201, CP3605, CP8001 and CP8002). 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. Remove the 4 screws 1. Remove the Angle Deck in the direction of arrow (A). Remove the 2 screws 2. Remove the Front Shield in the direction of arrow (B). Remove the 2 screws 3. Remove the Operation PCB in the direction of arrow (C). Disconnect the following connectors: (CP2601, CP2602 and CP2603). Remove the 4 screws 4. Remove the CD Deck in the direction of arrow (D). Remove the 4 screws 5. Remove the DVD PCB in the direction of arrow (E). 1-7: POWER PCB (Refer to Fig. 1-7) 1. Disconnect the following connector: (CP3603). 2. Remove the 3 screws 1. 3. Remove the Power PCB in the direction of arrow.
1 1 1
Power PCB
Bottom Plate Ass'y
NOTE When the installation of the Deck CD, remove all the soldering on the short circuit position after the connection of Pick Up PCB and DVD PCB connector.
Fig. 1-7
B1-2
|
|
 |
> |
|