|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
 ;
The manual was exact the thing that was promised. My old car stereo is working again thanks to the information supplied.
;
I PURHASED THIS PRODUCT BECAUSE I WAS HAVING PROBLEMS WITH MY CDR20 HARMAN KARDON RECORDER. WHICH I PURCHASED NEW 12 YEARS AGO. AFTER REVIEWING THE MANUAL, I WAS ABLE TO ADJUST THE TENSIONER IN THE SYSTEM. WORKS LIKE A CHAMP!.
SAVED ME AT LEAST 100.00 WHICH WAS WHAT A SERVICE REPAIR STATION WANTED. GREAT MANUAL EASY TO READ. SPECIALLY AFTER I PRINTED THE PAGES WHICH DEALT WITH MY RECORDER. THANKS A LOT!!!!!!!!
;
You can fully trust on this one!
All the schematics are very crear an in one piece per page
;
I have never bought a service manual which is as competely readable as this althogh it was a scanned pdf. Thank you for this succesful manual also cheaper than other sites.
DISASSEMBLY INSTRUCTIONS
1-5: TOP SHIELD ASS'Y (Refer to Fig. 1-5) 1. Remove the 9 screws 1. 2. Remove the Top Shield Ass'y in the direction of arrow.
4 1
Top Shield Ass'y CD Deck Pick Up PCB
4
1 1 1 1 1 1 1 1
Operation PCB
4 4 3 1 1
(D) Angle Deck Make the short circuit 1 using a soldering.
3
Front Shield
(C)
1
(B) (E) DVD PCB
2 2 5 5 5 5
(A) DVD/VCR Block
Fig. 1-5 Fig. 1-6 1-6: OPERATION PCB/DVD PCB/CD DECK (Refer to Fig. 1-6) 1. Make the short circuit on the position as shown Fig. 1-6 using a soldering. If you remove the Deck CD with no soldering, the Laser may be damaged. 2. Disconnect the following connectors: (CP2201, CP3605, CP8001 and CP8002). 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. Remove the 4 screws 1. Remove the Angle Deck in the direction of arrow (A). Remove the 2 screws 2. Remove the Front Shield in the direction of arrow (B). Remove the 2 screws 3. Remove the Operation PCB in the direction of arrow (C). Disconnect the following connectors: (CP2601, CP2602 and CP2603). Remove the 4 screws 4. Remove the CD Deck in the direction of arrow (D). Remove the 4 screws 5. Remove the DVD PCB in the direction of arrow (E). 1-7: POWER PCB (Refer to Fig. 1-7) 1. Disconnect the following connector: (CP3603). 2. Remove the 3 screws 1. 3. Remove the Power PCB in the direction of arrow.
1 1 1
Power PCB
Bottom Plate Ass'y
NOTE When the installation of the Deck CD, remove all the soldering on the short circuit position after the connection of Pick Up PCB and DVD PCB connector.
Fig. 1-7
B1-2
|
|
|
> |
|
