|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
GHOUNDING INSTRUCTIONS
Electrical ground CIRCUMSTANCES,
is required
on this appliance. DO NOT, UNDER ANY REMOVE THE POWER SUPPLY CORD GROUND PRONG.
8. Recommended
grounding
method
9. Alternate
grounding
method
GROUND USEMEL, (Al-LtCH 10 GPOUNDED COLD WATEll PIPE, -ELECTRICALLY GROUNDED COLD WAIT@ PIPE IREMOVE PAINI RE.,
3-PPONG
:POUNDING GROUNDING PLUG
k
PLUG
U
For your personal safety this appliance must be grounded. This appliance is equipped with a power supply cord having a 3-prong grounding plug. To minimize possible shock hazard, the cord must be plugged into a mating 3-prong grounding type wall receptacle which is correctly polarized and grounded in accordance with the National Electrical Code and local codes and ordinances. If a mating wall receptacle is not available, it is the personal responsibility and obligation of the customer to have a properly polarized and grounded 3-prong wall receptacle installed by a qualified electrician.
If changing and properly grounding the wall receptacle is impossible and where local codes permit (consult your electrical inspector], a temporary adapter may be plugged into the existing 2-prong wall receptacle to mate with the 3-prong power supply cord. THIS, HOWEVER, IS NOT RECOMMENDED. If this is done, you must connect the grounding eyelet on the adapter to the wall receptacle coverplate screw and from this same screw, you must connect a separate copper ground wire (No.16 minimum] to a grounded cold water pipe.+Do not ground to a gas supply pipe. Do not connect to electrical supply until appliance is permanently grounded. *Cold water pipe must have metal continuity to electrical ground and not be interrupted by plastic, rubber or other electrically insulating connectors (including water meter or pump] without adding a jumper wire at these connections.
Plug the oven into the proper electrical outlet and put about one cup (250 ml] of cold water in a glass container in the oven. Close the door. Make sure it latches. Follow the directions on page 9 to set the oven to COOK for 2 minutes. When the time is up, the water should be heated.
10.
11. This
microwave oven is designed for use in the household only and must not be used for commercial purposes. DO NOT remove the service panel, door, or control panel at any time. The unit is equipped with high voltage and should not be serviced unless by an authorized Whirlpool trained service technician.
|
|
|
> |
|
