|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Easy to order the manual. Good quality and fast delivery.
;
The Service Manual for Sansui AU-9500 was very helpfull, in complete and in good printable condition.
Thanks.
;
Dear Sir,
Document is original service document of sharp. I had a problem with the door contacts. Fuses where blown. With the manual in a few minuts is was clear what the problem was.
Manual was of great help.
With kind regards,
Martie Verhoeven
The Netherlands.
 ;
The scan is clear and well readable with very few weaker spots, usually on black background with white letters, but with enough zoom those spots can be read.
Printout is clear, the manual is complete and has all pages scanned.
I would give 5 stars, except that it is not in color, and the schematic and PCB pages are scanned on multiple pages. The document is locked (except printing) so the pages can not be extracted to compose them together for printing on the large plotter
It is worth the price tag.
;
let's say first that i do not need to have a credit for my opinion, i am a retired sparkie and i voluteerd to fix an electronic device for a local "Youthgroup",as no diagram was present i checked the "net" and gambled on this site and paying some fee via PayPall, i was gladly surprised that the manual arrived as was stated, GOOD SHOW, and best wishes, John
Note: When replacing/reassembling the infrared LED harness and MX ground wire, ensure that the cable length for the main frame R side as follows; Infrared LED harness: 130 ± 5mm MX ground wire: 65 ± 5mm
3.3.6 (1) Actuator A/B Release the hook on the right hand side on the rear cover B to remove it.
Main frame R
hook
Main frame R
Rear Cover B
Main frame L
Fig. 3.24
(2)
Remove the five idle gears 34, five swing arms and two gears 24 from the main frame R. Idle Gear 34
Swing arm Idle Gear 34 Swing arm
Swing arm
Idle Gear 34 Main frame R Idle Gear 24
Swing arm
Projection mark Main flap shaft Projection mark Fig. 3.25
Note: When reassembling the swing arm onto the main flap shaft, refer to the figure above.
III-15
|
|
|
> |
|
