I ordered this manual sometime in the afternoon and I received it on my e-mail the same evening.
This is a fantastically good and properly scanned copy of the original manual. All pages are of the same scale and they overlap each other. It means that you can print the manual and easily make it as a convenient paper manual.
The content of the manual is fantastic. Alignment descriptions, PCB layouts and elementary diagrams are explicit and precise. I immediately found what I was looking for. Thanks to this manual and Owner-Manuals.com my amplifier is alive again. Many thanx indded!
The manual was well-scanned and easy to read. As an added bonus, the Operator's Manual was bundled with the Service Manual!
I'd definitely use owner-manuals.com again.
Text excerpt from page 34 (click to view)
Note: When replacing/reassembling the infrared LED harness and MX ground wire, ensure that the cable length for the main frame R side as follows; Infrared LED harness: 130 ± 5mm MX ground wire: 65 ± 5mm
3.3.6 (1) Actuator A/B Release the hook on the right hand side on the rear cover B to remove it.
Main frame R
hook
Main frame R
Rear Cover B
Main frame L
Fig. 3.24
(2)
Remove the five idle gears 34, five swing arms and two gears 24 from the main frame R. Idle Gear 34
Swing arm Idle Gear 34 Swing arm
Swing arm
Idle Gear 34 Main frame R Idle Gear 24
Swing arm
Projection mark Main flap shaft Projection mark Fig. 3.25
Note: When reassembling the swing arm onto the main flap shaft, refer to the figure above.
III-15