|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Response is a little slow- I had to wait 12 hours to receive download link but it says that it may take up to 24hrs.
Manual is old and was not produced in PDF- scanned copy is exellent.
Overall- value for money- I recommend
 ;
Excellent quality and quickly delivered manuals at a fair price. Great care is taken in the reproduction process. Even photographs and highly detailed drawings are as clear as in the original. That cannot be said for some freelance manual copies I have obtained from the web. If you have exhausted your internet search of technical manuals, try Owner-Manuals.com. If they do not have it, I do not think it exists. Perhaps, if requested, they may be able to find it. Their resources are certainly greater than most. Shopping here certainly beats waiting for months or years for the manual you seek to appear in an internet auction or garage sale.
;
Very detailed product, also it is a scanning from original, very useful if you have to service this type of amplifier ! Very good product, very hard to find!
;
the Manual was made available as promised, the scans were excellent..Good Work !!!
;
It's complete and helpful manual with good quality of scan. Thanks very much.
MX-G68V/MX-G65V
Removing the tuner board (See Fig.11 and 13)
Prior to performing the following procedure, remove the metal cover and CD changer unit. 1. Disconnect the card wire from connector CON01 on the tuner board. 2. Remove the two screws L attaching the tuner board.
Main board CON01
Rear panel
Tuner board
Fig.13
Removing the rear panel
(See Fig.14)
Prior to performing the following procedure, remove the metal cover, CD changer unit, heat sink & amplifier board and tuner board. 1. Remove the one screw M, three screws N and three screws N' attaching the rear panel.
Rear panel
N' M N
Fig.14
Removing the main Board (See Fig. 15)
Prior to performing the following procedure, remove the metal cover, CD changer unit, heat sink & amplifier board, tuner board and rear cover. 1. Disconnect the card wire from connector FCW3 and the harness from connector JCW1, JCW2, ECW1 and HCW3 on the main board. 2. Disconnect the harness from connector PCW1 on the power transformer board. 3. Remove the screw G attaching the main board holder. (See Fig.8) 4. Remove the two screws O attaching the heat sink and bottom chassis.
FCW3 ECW1 JCW1 JCW2 HCW3 Main board
O
Transformer board
PCW1
Fig.15
1-8
|
|
|
> |
|
