JVC MXG71R
Service Manual

10

EN

GETTING STARTED (cont.)
Grip Adjustment

Power Zoom Lever

1 2 3

Separate the Velcro strip. Pass your right hand through the loop and grasp the grip. Adjust so that your thumb and fingers can easily operate the Recording Start/Stop Button and Power Zoom Lever. Refasten the Velcro strip.

Recording Start/ Stop button

Viewfinder Adjustment
1

1

Power Switch Diopter Adjustment Control Shooting Mode Dial

Set the Power Switch to � � or � � while pressing down the Lock Button located on the switch. Set the Shooting Mode Dial to any position. Pull out the viewfinder fully and adjust it manually for best viewability. Slide the Diopter Adjustment Control until the indications in the viewfinder are clearly focused.

2 3

PAUSE

Shoulder Strap Attachment

1
1 2 3

Following the illustration, thread the strap through the eyelet 1, then fold it back and thread it through the buckle 2. Repeat the procedure to attach the other end of the strap to the other eyelet 3, making sure the strap is not twisted.

Tripod Mounting

1

Align the screw and camera direction stud on the tripod with the camera�s mounting socket and stud hole. Then tighten the screw. �Some tripods are not equipped with studs.

CAUTION:
When using a tripod, be sure to open and extend its legs fully to stabilize the camcorder. To prevent damage to the unit caused by falling over, do not use a smallsized tripod.