JVC MXJ100
Owner's Manual

Adjusting the Volume
You can adjust the volume level only while the unit is turned on. Turn VOLUME clockwise to increase the volume or counterclockwise to decrease it.
VOLUME

Reinforcing the Bass Sound
The richness and fullness of the bass sound is maintained regardless of how low you set the volume. You can use this effect only for playback. To get the effect, press ACTIVE BASS EX. so that the BASS indicator appears on the display.
�
ACTIVE BASS EX.

+

VOL

When using the remote control, press VOL. + to increase the volume or press VOL. � to decrease it.

To cancel the effect, press the button again so that the indicator also goes off.

For private listening Connect a pair of headphones to the PHONES jack. No sound comes out of the speakers. Be sure to turn down the volume before connecting or putting on headphones on the unit. DO NOT turn off (on standby) the unit with the volume set to an extremely high level; otherwise, a sudden blast of sound can damage your hearing, speakers and/or headphones when you turn on the unit or start playing any source next time. REMEMBER you cannot adjust the volume level while the unit is on standby.

Selecting the Sound Modes
You can select one of the 3 preset sound modes (3 SEA � Sound Effect Amplifier � modes). The sound modes can be applied only to playback sounds, and cannot be used for recording. To select the sound modes, press SOUND MODE until the sound mode you want appears on the display. The SOUND indicator also lights up on the display.
SOUND
SOUND MODE

To turn down the volume level temporarily
Press FADE MUTING on the remote control.
FADE MUTING

VOL

� Each time you press the button, the sound modes change as follows:

(Canceled)
VOL

SEA modes: ROCK: Boosts low and high frequency. Good for acoustic music.

To restore the sound, press the button again.

POP: Good for vocal music. CLASSIC: Good for classical music. OFF: Cancels the sound mode.

� 10 �