|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
 ;
We received the manual in a timely manner and it was exactly what we were expecting.
;
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
;
Very good scanning quality. All schematics are very legible. Worth every cent !
MX-J50
< Rear Panel Assembly >
Prior to performing the following procedure, remove the metal cover and the CD changer mechanism assembly. The following procedure can be performed even if the front panel assembly is attached.
Rear panel
S
T
Removing the Rear Cover (See Fig.18)
1. Remove the two Q screws attaching the rear cover on the back of the body.
Q S S S
Q
Removing the Rear Panel (See Fig.18 to 21)
Prior to performing the following procedure, remove the rear cover. 1. Remove the four R screws attaching the heat sink and the rear panel. 2. Remove the ten S screws attaching the rear panel. 3. Remove the two T screws attaching the voltage selector and the rear panel. (Only Ver.U type) 4. Release the two joints(d) and (e) on the lower part of the rear panel using a screwdriver, and remove the rear panel toward the rear side.
Rear cover
S
Fig.18 Rear panel
R
R
Heat sink Fig.19
Joint(d) Fig.20
Joint(e) Fig.21
2-22
|
|
|
> |
|
