|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
- Safety Precautions
- Important for Laser Products
- Precautions at Disassembling and Parts Replacement
- Instructions
- Disassembly Method
- Adjustment Method
- Diagnosis which Uses Extension Wire Method
- Flow of Functional Operation until TOC Read
- Maintenance of Laser Pickup
- Replacement of Laser Pickup
- Description of Major ICs
- Block Diagrams
- Standard Schematic Diagrams
- Printed Circuit Boards
- Parts List
There are currently no product reviews.
 ;
I bought the service-manual of the sony ICB-1020(an old transmitter-receiver) at "www.Owners-Manual.com", I found the service-manual for a fairly cheap price(in comparison with other sellers). I filled in some questions, payed the order with Ideal, and within 24 hours I had my service manual. I was very happy:In no time I had my service-manual and everything, but literally everything was noted down in the manual; the electronic scheme, the parts list, etcetera.
A very practical, reference-document.
 ;
This comprehesive service maual was greatly appreciated, as was the digital download.
;
Good en helpfull black and white scanned Srfvice manual of the Philps D8444. Quick service and delivery
;
Scan was really good quality, easy to read, download easy
;
very good manual as always. easy to read, detailed and includes schematic
MX-J500/MX-J506
<Rear panel assembly> Removing the tuner board (See Fig.19 and 20)
Prior to performing the following procedure, remove the metal cover. 1. Remove the two plastic rivets attaching the joint board, and remove the joint board. 2. Disconnect the card wire from connector CN1 on the tuner board. 3. Remove the two screws R attaching the tuner board on the back of the body.
CN712 S CN711 Input / output board Joint board Plastic rivets Tuner board CN1 Rear panel CN871
CN870
CN315
Fig.19
Removing the input / output board (See Fig.19 and 20)
Prior to performing the following procedure, remove the metal cover. 1. Remove the two plastic rivets attaching the joint board, and remove the joint board. 2. Disconnect the card wire from connector CN315 on the input / output board. 3. Remove the screw S attaching the input / output board on the lower right side of the body. 4. Remove the screw, E & F attaching the input / output board on the back of the body. 5. Disconnect connector CN870, CN871, CN711 and CN712 on the input / output board by pulling out them outward. Remove the input / output board from the body. Fig.20
Rear panel
R
E
(Only the model by which a digital output is installed)
F
2-8
|
|
|
> |
|
