|
Who's Online
There currently are 5858 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I found this manual to be complete in every detail. Besides the schematic it has a complete set of alignment instructions which are easy to understand. It also includes a complete parts list as well as an explanation of how the power supply and safety shutdown circuits operate. Even a schematic of the tuner is included.
;
The product was good and just what I needed, however I had moderate difficulty with the down load because the sight would not recognize my pass word. I was finally given a direct link to the manual and that worked.
;
Very quick and easy website to use and fast download of manual, quality of manual is excellent and will be pleased to use this service again in the future, thanks so much!
;
It is an very good and clear scanned service manual.
very recommended.
;
Easy to order the manual. Good quality and fast delivery.
n Removing the CD pickup (See Fig.18)
n
Prior to performing the following procedures, remove the top cover and both sides board. Also remove the CD changer unit. Also remove the CD changer mechanism.
n n
1. Widen the section "f". 2. While keeping the section "f" wide open, push the section "g" in the direction of the arrow to remove the shaft, and then remove the CD pickup.
n Replacing the loading motor and rotor belt
of the CD changer (See Fig .19)
n
Prior to performing the following procedure, remove the top cover. Also open the CD changer tray.
n
1. Remove the two screws "L" retaining the CD changer tray loading motor. 2. Remove the two screws "M" retaining the gear plate and take it out, after remove the rotor belt from the pulley.
n Replacing the CD turn table and removing the motor (See Fig. 20 and 21)
n
Prior to performing the following procedures, remove the top cover. Also remove the CD changer unit.
n
1. Remove the one screws "N" retaining the CD (Turn table). 2. Remove the two screws "O" retaining the stopper brackets on both sides of the CD changer unit. 3. Remove the stopper brackets from both sides of the CD changer unit. 4. Pull out the CD tray from the CD changer unit, all the way and lift the tray (u/~ ward) to remove. 5. Remove the gear and after push out the tray motor locker and pull out the tray motor from the CD tray.
1-13
|
|
|
> |
|