JVC MX-K35V
Owner's Manual

English

Using the Timers
Using the Unit You can set the time in the same way as for setting the Daily Timer.

1 2

Insert a blank or erasable tape into the Deck B and wind past the tape leader. Press the CLOCK/TIMER button until �ON TIME� immediately after �REC� appears on the display.
Then, the �REC� indicator blinks on the display. Each time you press the button, the display changes as follows: DAILY = ON TIME = REC = ON TIME* = Clock setting display = Canceled = (back to the beginning)

When the timer ON-time comes: � When the timer ON-time comes, the System automatically turns on. The station you have set is played. The Timer indicator ( ) blinks during timer operation. To stop timer recording, press the 7 button. � When the timer OFF-time comes, �OFF� blinks on the display just before the OFF-time and the System automatically turns off.

� The REC Timer works even if the System is turned on.

Turning the REC (Recording) Timer On and Off
Once you have set the REC Timer to record a source, the timer setting is stored in memory. So, though the REC Timer turns off once it is used, you can recall it at any time.
To cancel the REC Timer temporarily:

* : This item should be selected for the REC Timer setting.

After 2 seconds, the System enters ON-time setting mode. The current ON time appears on the display and the hour digits blink.

1
After 2 seconds
REC

Press the CLOCK/TIMER button on the Unit repeatedly until �REC� appears on the display. Press the CANCEL button on the Unit.
�OFF� appears and the �REC� indicator goes out.

2
REC

To activate the cancelled REC Timer:

3

Setting the ON time you want the System to turn on.
1. Press the 4 or ¢ button to set the hour, then press the SET button. 2. Press the 4 or ¢ button to set the minute, then press the SET button. �OFF TIME� appears for 2 seconds, and the System enters OFF-time setting mode. The current OFF time appears on the display, and the hour digits blink.

1

Press the CLOCK/TIMER button on the Unit repeatedly until �REC� appears on the display.
The �REC� indicator also blinks on the display.

2

Press the SET button on the Unit.
The �REC� indicator remains lit. Each setting already made appears on the display in the order of ON time, OFF time, and the preset number, and then the display returns to the original display.

4

Setting the OFF time you want the System to turn off.
1. Press the 4 or ¢ button to set the hour, then press the SET button. 2. Press the 4 or ¢ button to set the minute, then press the SET button. The System enter Preset Station Entering mode.

CAUTION:
� If the System is unplugged, or a power failure occurs, the timer setting will be lost in a few days. You will need to reset the clock first, then the timer.

5

Select the preset station for recording.
1. Press the 4 or ¢ button to set the band (TUNER FM or TUNER AM), then press the SET button. 2. Press the 4 or ¢ button to set the preset number, then press the SET button. The REC indicator stops blinking and remains lit. � Each setting you have made appears on the display in the order of ON time, OFF time, radio band and the preset number.

6

Press the % button to turn off the System, if necessary.

To change the timer setting, repeat the setting procedure from the beginning.

27