|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I never been disappointed in my dealings with owners-manuals.com
;
Excellent printing quality. A complete and very useful manual with all details.
;
Even if the PDF is a scan, I can read the information I need.
The price is affordable and the service (mail sending) is very fast.
Thanks ! Regards. William (Fan of Kenwood)
;
Very good quality original datasheet!I like this amazing website!!!!!!
 ;
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
MX-KA66
<Disassembly of units and assembly inside this set>
Removing the CD PCB (See Fig.12 to 13)
Prior to performing the following procedures, remove the top cover. Also remove the CD changer unit. 1. Disconnect the wires from CN603A, CN603B and CN604 on the CD PCB, which is located on the back side of the CD changer unit. 2. The four screws J that retain the CD PCB should be removed. 3. Remove the CD PCB by pulling it toward the side where the CN601 is located. 4. Using solder, short the CD pickup to connect to short round. [Caution] After re-connecting the wires, be sure to remove the shorting solder from the GND connection. 5. Disconnect the card wire from the connector CN601 on the main PCB and then remove the main PCB.
J
CD PCB
J
J
Fig.12
CD PCB CN601
Short round
Fig.13
1-10
|
|
|
> |
|
