|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual is complete with excellent quality! One suggestion, show number of pages and weather it is multi-lingual. The AD 600 Manuel is about 76 pages and over half is non English. This results in a larger print job than usually needed. Having this information, one could select the desired pages for printing.
 ;
I've been looking for a copy of the original user/owner manual. Just what the doctor ordered, thank you.
;
the manual was very helpful thank you very much no one else was able to help me thanx
;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
English
AM antenna
Connecting Speakers
You can connect the speakers using the speaker cords.
1
2
3
1
2
3, 4
Vinyl-covered wire (not supplied) Red
Red
AM loop antenna (supplied) Black
Black Speaker cord (Supplied with Red Black your speakers)
Red
1 2
Connect the AM loop antenna to the AM LOOP terminals as illustrated. Turn the AM loop antenna until you have the best reception.
Right speaker
Left speaker
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.)
1 2 3 4
Twist the core of the cord at the end of each cord, then remove the insulation. Open the speaker terminal. Insert the end of the speaker cord to the terminal. Match the polarity of the speaker terminals: Red (+) to red (+) and black (�) to black (�). Close the speaker terminal on the rear of the unit.
For better reception of both FM and AM � Make sure the antenna conductors do not touch any other terminals and connecting cords. � Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.
Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.
�7�
|
|
|
> |
|
