|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good product. Best service manual. Many thanks
;
I am only search for 5 Minute, by it in 5 Minutes to and get ist in few ours! Best i found in the Internet and my Amplifer is repaired as well! Thank you
 ;
Readable text and good copy. Very much needed if you wish to do some repairs on this fine old unit.
;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
Key Check Mode
This set can check if the set and remote commander function normally. � Setting Method of Key Check Mode 1. Setting the test mode (see page 12). 2. Press the [DISPLAY] key for several seconds (about 3 seconds) activates the key check mode. (At the last two digits, AD value of remote commander key line is displayed in hexadecimal)
Remote commander LCD display
4. When all the keys on the set and on the remote commander are considered as OK, the following displays are shown for 4 seconds. (The key pressed to enter the Key Check mode has been checked even if it is not pressed in this mode) Example1: When the keys on the set are considered as OK:
Set LCD display All lit
888
Remote commander LCD display
000
**
888 SET OK **
**: AD value of the remote commander key (hexadecimal 00 to FF) Example2: When the keys on the remote commander are considered as OK:
Set LCD display
**: AD value of the remote commander key (hexadecimal 00 to FF) 3. When each key on the set and on remote commander is pressed, its name is displayed on the remote commander LCD. (The operated position is displayed for 4 seconds after the slide switch is operated. If any other key is pressed during this display, the remote commander LCD switches to its name display.) Example1: When >/N key on the set is pressed:
Remote commander LCD display
888
All lit
Remote commander LCD display
000 FF
**
888 RMC OK **
**: AD value of the remote commander key (hexadecimal 00 to FF) 5. When all the key have been checked, the system terminates the Key Check mode and return to the test mode (display check mode).
**: AD value of the remote commander key (hexadecimal 00 to FF) Example2: When N > key on the remote commander is pressed:
Remote commander LCD display
000 rPLAY
**
**: AD value of the remote commander key (hexadecimal 00 to FF)
� 16 �
|
|
|
> |
|
