|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
To start/stop recording in sync with the source player (Synchro-recording)
You can easily make digital recordings of a digital source on an MD. Before synchro-recording, make connections to the digital source with a digital cable, and insert a recordable MD.
CD players, etc.
3 4 5
Press SELECT >/. repeatedly until �ON� flashes in the display, and then press MENU/ENTER. Press N while pressing REC. The recorder stands by for recording. Play the source sound. The recorder starts recording when it receives the playing sound.
To stop recording Press x.
z
� You cannot pause manually during synchrorecording. � When there is no sound from the player for more than 3 seconds during synchrorecording, the recorder goes into the standby mode automatically. When the sound comes from the player again, the recorder resumes synchro-recording. If the recorder is kept in the standby mode for 5 minutes or longer, the recorder stops automatically. � For longer recording, follow steps 1 to 3 of �Recording for long times� (page 16) to select the recording mode, and then start the procedure of synchro-recording.
REC N
Notes SELECT >/.
� Do not change the �SYNC-R� setting while recording. Recording may not be done properly. � Even when there is no recorded sound on the sound source, there may be cases when recording does not pause automatically during synchro-recording due to the noise level emitted from the sound source. � If a silent portion is encountered for 2 seconds or more during synchro-recording, a new track mark is automatically added at the point where the silent portion ends. � Synchro-recording cannot be done if the connecting cord is not an optical cable. � You cannot adjust the recording level manually during synchro-recording.
MENU/ENTER
1 2
Press MENU/ENTER while the recorder is stopped. Press SELECT >/. repeatedly until �SYNC-R� flashes in the display, and then press MENU/ ENTER. �SYNC� lights up in the display.
SYNC indication
�SYNC� does not lights up if optical cable is not connected to the recorder.
18
|
|
|
> |
|
